Tendon Type 68...	01	02	03	04	05	06	07	08	09	10	12	15	19	22	27	31	37
Plate Anchorage Type ED
Multiplane Anchorage MA
Loop Anchorage HV
Bond Head Anchorage ZF / ZR
Plate Anchorage SD
Flat Anchorage FA

other size tendons upon request

Plate Anchorage Type ED

The two-part plate anchorage can be used in slabs and similar structures, e.g. transversal prestressing in bridge decks. The wedge plate self-centers on the anchor plate, providing consistent assembly and installation as well as trouble-free stressing.

stressing anchorage dead end anchorage accessible not accessible yes yes yes ultimate load [kN] from to 721 1,395 Plate Anchorage Type ED -Technical Details

Multiplane Anchorage MA

The two-part multiplane anchorage is primarily used for longitudinal tendons in beams and bridges. The wedge plate and the conical anchor body with usually three load transfer planes introduces the prestressing force continuously into the member with minimal front area. The separation of anchor body and wedge plate makes it possible to insert the strand after casting the concrete. The wedge plate self-centers on the anchor body, providing consistent assembly and installation as well as trouble-free stressing.

stressing anchorage dead end anchorage accessible not accessible yes yes yes coupling ultimate load [kN] from to yes 1,201 10,323 Multiplane Anchorage MA - Technical Details

Loop Anchorage HV

Often used in large plate-shaped structures, walls in off-shore structures or LNG tanks with generally static loadings. The 180° loop should be positioned in the center of the tendon to allow for non-slippage during simultaneous two-end stressing.

stressing anchorage dead end anchorage accessible not accessible no no yes coupling ultimate load [kN] from to no 721 6,138 Loop Anchorage HV - Technical Details

Bond Head Anchorage ZF/ZR

Primarily used with prefabricated tendons, it is also possible to fabricate this anchorage on site. The strand wires are plastically deformed to ensure a safe load transfer up to ultimate capacity in the area of the bond head proven in static as well as in dynamic applications. Depending on the boundary conditions, either a rather flat or a bulky bond head anchorage pattern is available.

stressing anchorage dead end anchorage accessible not accessible no no yes coupling ultimate load [kN] from to no 721 6,138 Bond Head Anchorage ZF/ZR - Technical Details

Plate Anchorage SD

The single unit plate anchorage is designed for plate structures as well as transverse tendons in bridges. Small edge and center distances allow for an economical anchorage layout in condensed situations.

stressing anchorage dead end anchorage accessible not accessible yes yes yes coupling ultimate load [kN] from to no 721 2,511 Plate Anchorage SD - Technical Details

Flat Anchorage FA

The Flat Anchorage of max. 4-0.62" strands in one plane to deviate into one oval duct is designed to be installed in thin members such as transverse Post-Tensioning of the top slab of box-girder bridges and prestressed flat slabs.

stressing anchorage dead end anchorage accessible not accessible yes yes yes coupling ultimate load [kN] from to no 721 1,116 Flat Anchorage FA - Technical Details